This page is part of archived documentation for openHAB 3.4. Go to the current stable version
# GPIO Binding
This binding adds GPIO support via the pigpio daemon to openhab. It requires the pigpio (http://abyz.me.uk/rpi/pigpio/ (opens new window)) to be running on the pi that should be controlled.
# Supported Things
# pigpio-remote
This thing represents a remote pigpio instance running as daemon on a raspberry pi.
# Thing Configuration
# Pigpio Remote (pigpio-remote)
On a raspberry (or a compatible device) you have to install pigpio:
sudo apt-get install pigpiod
sudo raspi-config
-> Interfacing Options --> Remote GPIO --> YES --> OK --> Finish
Note: if you are setting this up on a Raspberry Pi without raspi-config you can create the service config file manually:
sudo mkdir -p /etc/systemd/system/pigpiod.service.d/
sudo nano /etc/systemd/system/pigpiod.service.d/public.conf
[Service]
ExecStart=
ExecStart=/usr/bin/pigpiod
sudo systemctl daemon-reload
Now that Remote GPIO is enabled, get the daemon going (even if installed with apt-get):
sudo systemctl enable pigpiod
sudo systemctl start pigpiod
In openHAB, set host to the address of the pi and the port to the port of pigpio (default: 8888).
Note: If you are running Pigpio on same host as openHAB, then set host to ::1.
# Channels
# Pigpio Remote
| channel | type | description |
|---|---|---|
| pigpio-digital-input | Switch | Read-only value of the gpio pin |
| pigpio-digital-output | Switch | Controls the gpio pin |
# GPIO digital input channel
Set the number of the pin in gpioId.
If you want to invert the value, set invert to true.
To prevent incorrect change events, you can adjust the debouncingTime.
Using pullupdown you can enable pull up or pull down resistor (OFF = Off, DOWN = Pull Down, UP = Pull Up).
# GPIO digital output channel
Set the number of the pin in gpioId.
If you want to invert the value, set invert to true.
# Full Example
demo.things:
Thing gpio:pigpio-remote:sample-pi-1 "Sample-Pi 1" [host="192.168.2.36", port=8888] {
Channels:
Type pigpio-digital-input : sample-input-1 [ gpioId=10]
Type pigpio-digital-input : sample-input-2 [ gpioId=14, invert=true]
Type pigpio-digital-output : sample-output-1 [ gpioId=3]
}
Thing gpio:pigpio-remote:sample-pi-2 "Sample-Pi 2" [host="192.168.2.37", port=8888] {
Channels:
Type pigpio-digital-input : sample-input-3 [ gpioId=16, debouncingTime=20]
Type pigpio-digital-input : sample-input-4 [ gpioId=17, invert=true, debouncingTime=5, pullupdown="UP"]
Type pigpio-digital-output : sample-output-2 [ gpioId=4, invert=true]
}
demo.items:
Switch SampleInput1 {channel="gpio:pigpio-remote:sample-pi-1:sample-input-1"}
Switch SampleOutput1 {channel="gpio:pigpio-remote:sample-pi-1:sample-output-1"}
demo.sitemap:
sitemap demo label="Main Menu"
{
Switch item=SampleInput1
Switch item=SampleOutput1
}